Back
You can administer the system using several components:
- System on/off – to enable or disable the system
- Shutdown all – to shutdown all computers & equipments in your organization
- Wake up all – send the “Wake up” command to all computers and equipment
- Maintenance window – to set up a time to wake up the computers for system maintenance and then shut them down again afterworks
- Site preferences – to configure the system parameters
- Network discovery – shows the network devices connected to your network
[edit] System On/Off
[edit] Shutdown all
[edit] Wake up all
[edit] Maintenance window
[edit] Site Preferences
In here you can set the following:
- CO2 Per unit = The amount of CO2 produced per unit of electricity used
- Cost per unit = The cost of one unit of electricity
This is then used in the calculations on the site and can be adjusted as and when needed.
This page also shows the following information
- Admin Last Run = The last time the Admin logged in
- Client Licenses = The Maximum number of User licenses for the Server
- Client Licenses Expire = the date the licenses run out
- Controller_count = Number of controllers registered to the Server
- Gateway = The Gateway address of the Server
- IP_address = The IP address of the Server
- Licensed to = Who the Server is Licensed to
- Message_sweep =
- Netmask = The Network mask of the Server
- Server serial number = The serial number of the Server
[edit] Network discovery
Back